JETWAY 993AN DRIVER DOWNLOAD

Discussion about old PC hardware. The author assumes no responsibility for any errors or omissions which. Suspend Monitor blanked when the systems enters the Suspend mode. The parameters in this screen are for system designers, service personnel, and technically competent users only. The turbo LED will remain constantly lit while the system power is on.

Uploader: Shatilar
Date Added: 18 September 2015
File Size: 39.7 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 29318
Price: Free* [*Free Regsitration Required]

The Mother Board • View topic – Jetway AN motherboard

The parameters in this screen are for system designers, service personnel, and technically competent users only.

This section covers some very technical items and it is strongly recommended that only experienced users should make any changes to the default settings. Please note that you have to jetwaay the MD in the simultaneous-recording mode. Table of Contents Add to my manuals Add.

Monitor will remain on during power saving modes. Standby Monitor blanked when the system enters Standby mode. By means of this setting box, you can also complete the above-mentioned setting procedures. If you are not an experienced user, please do not change the default setting. Discussion about old PC hardware. There is no material that is knowingly illegal here.

Last Drivers  LINKSYS ROUTER WRT610N DRIVER DOWNLOAD

Jetway AN Manuals

Suspend Monitor blanked when the systems enters the Suspend mode. Install Expansion card 5. Page 41 About Recording 24bit Audio Setting The Power Management Setup allows you to configure you system to most effectively save energy while operating in a manner consistent with your own style of computer use.

The turbo LED will remain constantly lit while the system power is on.

Jetway 993AN ATX Motherboard CPU 4x PCI 2x IDE 1x ISA Intel socket 370 & Slot 1

Page 12 Heatsink Attachment Step 1 Remove the protective liner from the thermal interface material on the underside of the heatsink. I ask because i’ve just tried to install one in said mobo and it’s not picking it up.

USB Port Connector 4. Page 36 Mute Buttons: Pentium is registered trademark and MMX is a trademark of Intel corporation.

Got it, continue to print. Don’t show me this message again. Pin 1 Floppy drive Connector 7. Locate the ZIF Socket and open it by first pulling the lever sideways away from the socket then upwards to a degree right angle.

Last Drivers  DFI AD73 PRO DRIVER

The Mother Board

Connect a jumper Cap over this jumper for a few seconds, will clears information stored in the CMOS RAM Chip that input by user, such as hard disk information and passwords. By pressing ‘print’ button you will print only current page. Page 25 Monitor will remain on during power saving modes. Page 35 Current Time field: Audio and Game Connector: However this could be because I may have been a bit over-zealous with the thermal paste, and the cooler was a bit of a bugger to fit back in again Regarding a different motherboard: You may wish to connect the Power LED from the system case to this lead.

Set any necessary jumpers on your expansion card. Hardware Installation Chapter 2 Hardware Installation Unpacking This mainboard package should contain the following: Page 47 Please follow these setting procedures.

Google [Bot]hard1klooking4awayoutMMaximus and 8 guests.